DR5000 Operational Status LED
located below the Keypad
The Status LED Indicator [green] provides the following to an operator:
-
LED is not on:
- Indicates there is no power to the recorder.
-
LED is on steady & pen(s) within chart range:
- Unit is operating normally.
-
LED is on steady & pen(s) above 100% mark on chart range.
- Unit is in Change Chart Mode; Action - depress Change Chart Key to return to normal operation.
-
LED Flashing RAPIDLY & pen(s) within chart range:
- Indicates optional 9VDC battery is low; Action - replace battery.
-
LED Flashing RAPIDLY & pen(s) at 0% or 100% of chart range:
- Indicates sensor break or PV is out of programmed chart range.
-
LED Flashing Slowly [0.8 seconds]:
-
Unit in Set up or in Sensor Offset Mode:
- Sensor Offset Mode: Complete Offset and/or unit will time out in less than 10 seconds and return to normal operation.
- Set up Mode: There is no time out in Set up Mode; complete Set up or power down & up the recorder to exit Set up.
-
Unit in Set up or in Sensor Offset Mode: